Hydraulic shock absorber with the pressure gauge

(VT.CAR20.I) Hydraulic shock absorber with the pressure gauge VT.CAR20 is a new model based on the well-proven VT.CAR19 shock absorber. The main feature of the new version is the ability to control the pressure in the air chamber. This is very important because if the pressure in the chamber drops below designed value, the absorber will not be able to fully perform its functions (in addition to smoothing out the hydraulic shocks, the device receives an excessive volume of water formed by heating of incoming cold water).

To control the VT.CAR20 performance, into the nipple fitting design a miniature ball valve with the pressure gauge were introduced. A tenant may at any time open the valve and check the pressure in the air chamber of the absorber.

Hydraulic shock absorber VT.CAR 20 consists of a miniature AISI 304L stainless steel tank with an internal separating membrane made of EPDM. Body of the ball valve is made of CW617N nickel-plated brass.

Technical characteristicsValues
Working volume, l0,155
Factory setting of the initial pressure in the air chamber, bar 3,0
Maximum pressure at the hydraulic shock, bar20
Recommended working pressure in the housing tubing at the factory set pressure in the air chamber, bar2,8
Maximum working pressure in the housing tubing, bar 10
Pressure gauge range, bar0–6
Temperature range of working medium, °C–10… +100
The average service life, years 20

ArticleSize / number ofPrice per unit
VT.CAR20.I.040010,155 l2470 ₽
* Prices shown are recommended retail prices by the manufacturer

 

Hydraulic impact dampers